Hardware
- > Introduction
- > PCB
- > Cables
Firmware
- > Introduction
- > HEX files
Software
- > Introduction
- > Download
- > User guide
Other
- > Home
- > Links
Site Designed for 1024x768
Installation - Basics - Output setup - Setting addresses - Direct Control - Sequences - Playlists - Running Playlists
The Playlist editor is used to create playlists of upto 256 sequences, which can then be run by a different part of the progra, the interface of the playlist editor is shown below:
Basically its just a list of file paths, these can be typed in manually, or the browse button can be used, the radio button on the left hand side should be set to the last sequence on the playlist that you want to be run, the fields on the right hand side of the list of files are detailed below:
Pause - Delay in milli-seconds between each step of the sequence
Repeat - Number of times the sequence should be repeated in each itteration of the playlist, enter zero and it will be run once, but not repeated, enter one, and it will be run two times in total, and so on.
Steps - The number of steps in the sequence, you won't always want 256 steps in a sequence ...