Hardware
- > Introduction
- > PCB
- > Cables
Firmware
- > Introduction
- > HEX files
Software
- > Introduction
- > Download
- > User guide
Other
- > Home
- > Links
Site Designed for 1024x768
Installation - Basics - Output setup - Setting addresses - Direct Control - Sequences - Playlists - Running Playlists
This part of the program allows you to have direct, real time control over the outputs, this is usful for testing purposes, the interface is shown below:
Basically you select the number of the box you want to work on, and then toggle the outputs on that box by using the buttons at the bottom of the interface, there are also butons to switch the entire box on or off for convenience, as well as buttons that do the same for all of the boxes, the on button on this asks if you are sure before switching everything on, because this feature could case an electrical overload in some uses of the icicle system.