Site Designed for 1024x768
Installation - Basics - Output setup - Setting addresses - Direct Control - Sequences - Playlists - Running Playlists
This part of the program is only designed for output types that have their addresses set in software (such as the icicle boards), trying to use it on an output type its not designed for will result in the following error message
Using the address setting part of the program is easy to use, just a few simple instructions:
Step one - Ensure that the output settings are correct for the output you have connected
Step two - Get the board ready to accept an address (see the information about the board hex file for how to do this)
Step three - Launch the Set Address part of the program from the Output menu
Step four - click the button which corresponds with the address you want to set the box to (it will turn grey)
Step five - Click the go button and the box will aknowledge receipt of the address and enter normal working mode (see hex file information for more details)
Entire site, Icicle software, firmware and other content © 2003-2005 electro-zone.co.uk unless stated otherwise.
"PayPal" is a trademark of PayPal, Inc."Windows" is a registered trademark of Microsoft Corporation. All other marks are the trademarks or service marks of their respective owners
All content on this site is distributed for free and without warrenty, you may not sell any of this content, nor use it for commerical gain. You may however distrubute the content free of charge, however it would be preferable if you refer any interested parties this website.